TRONXY Gemini S& Gemini XS IDEX 3D Printer How to Level and E-Offset2022-04-27
Use the E1 print head to level the hot bed platform
Click "System"→"Mode"→"Autopark" mode→"Tool"→Select"Level"→"Manual"
According to the sequence given, level the five positioning points one by one, please repeat the leveling operation twice, the leveling is more accurate.
Operation instructions
1. Adjust the distance between the hot bed and the nozzle through the big nut under the hot bed, use A4 paper to judge whether the distance is appropriate.
2. When adjusting the center position of the hot bed, need to adjust the position of the four corners of the platform.
(That is, adjust the nuts of the four corners of the hot bed through the same operation to adjust the center position. )
3. How to confirm that the distance is appropriate?
Can feel the slight resistance given by the nozzle when dragging the A4 paper.
Leveling the E2 print head
Click "Manual"→"Home"→"E1" to switch to "E2", Loosen the two screws.(Don't take it off).
After loosening the two screws, the E2 print head can move up and down by twisting the upper screw.
Note the direction of adjustment, adjust the distance between the nozzle and the hot bed close to the thickness of A4 paper.
After completing the adjustment, retighten the two screws on the E2 head.