Blog

TRONXY 3D Printer D01 Printing Video

TRONXY 3D Printer D01 Install Video

LCD backlight turns on but display nothing; LCD display normal but the button (knob) is not response; LCD show error characters

Motor of X,Y or Z can not work; Motor direction of X，Y or Z are not correct; Abnormal noise are made when motor working; X,Y or Z motor can only turns in one direction; Motor of extruder don’t work; Extruder rotates but does not feed the material

Hot end cannot warming or heating up slowly; Extruder cannot heat up to setting temperature; Temperature of extruder bounced with large range when heating; Extruder motor sounds”Ka-Ka” noise when printing

Heat bed don’t heating; When heat bed start heating, the control board restart automatically; Heat bed heating but can’t reach to setting temperature

Documents in SD card cannot be found; Direct stop in the printing process; Cannot start after chose a file when your SD-card printing

Cannot connect to PC

Why the filament can’t stick on the heat bed

Problem of Z aixs lead screw